6 inch safety wire twisting pliers with black oxide finish, serrated jaws, side cutter and knurled automatic-return knob

9 inch safety wire twisting pliers with black oxide finish, serrated jaws, side cutter and knurled automatic-return knob

Safety Wire Twisting Pliers – Lockwire Twister (6″ & 9″)

¥174.68

Length 6″ (150 mm)

6″ (150 mm) 9″ (230 mm)

✓ 有库存可用 10 件✓ 从澳大利亚发货

更多付款方式

收货方式

✓ 下一工作日发货

✓ 60 天退货

完整配送政策

预计送达

产品信息使用方法技术规格评价推荐产品

产品信息

Safety wire twisting pliers make lockwiring fast, consistent and repeatable. Clamp the wire in the jaws, lock them shut, then draw the spiral shaft back - the tool spins itself and lays a clean, even twist. The result is the tight, uniform lockwire that aviation, motorsport and marine work demand, without the fatigue and inconsistency of twisting by hand.

Both sizes share the same hardened alloy steel construction, black oxide finish, serrated jaws and built-in side cutter. The difference is reach and leverage:

6″ (150 mm) - the everyday choice. Lighter in the hand and easier to work in confined bays, around brackets and between close-set fasteners.
9″ (230 mm) - more leverage and a longer pull, so each stroke lays more twist. Better suited to heavier gauge wire and longer runs where you want fewer strokes.

Plenty of workshops keep both on the bench: the 6″ for tight access, the 9″ for bulk work.

These are automatic-return twisters with a fixed twist direction - the standard, most economical pattern, and the one most workshops reach for.

特点

Twists lockwire fast and evenly — one smooth pull per twist
Automatic return shaft resets the tool ready for the next run
Hardened alloy steel with a black oxide finish
Serrated jaws grip the wire; built-in side cutter trims the tail
Choose 6″ for confined spaces or 9″ for extra leverage

使用方法

Thread the safety wire through the fastener and bring the two tails together.
Grip both tails in the jaws, as close to the fastener as you can.
Squeeze the handles tight, then push the perforated silver collar forward towards the handles. This locks the jaws shut so they cannot open, holding the wire securely while you twist.
Draw the spiral shaft back in one smooth stroke. The tool spins itself and lays an even twist along the wire.
Let the shaft return, then slide the silver collar back to unlock the jaws and release the wire.
Trim the twisted tail with the built-in side cutter and tuck the cut end safely out of the way.